Sturtevant Richmont

There are a variety of pneumatic torque controlled tools that accommodate high speed assembly. The very nature of high speed assembly creates opportunities for errors. Operators moving too fast can miss tightening some fasteners, attempt to tighten previously tightened fasteners, cross-thread, or release the trigger before final torque is achieved.
The PST, in conjunction with the Global controller can:
• Batch count to ensure all fasteners achieved target torque
• Identify previously tightened fasteners that are attempted again
• Be set to identify cross threaded fasteners at installation
• Identify premature “clutch out” when the operator releases the tool trigger or lever prior to target torque
The PST Series works with most trigger or lever activated, ported torque sensing power tools. Whether a continuous drive, or shut-off pulse tool, the PST monitors air pressure in the motor compartment while applying timers to the various stages of the “run down.” This algorithm is created during the auto-cal process and is used to validate or reject all fastenings performed by that tool.
The PST Pressure Sensor Transceivers will provide a more robust assembly process from your pneumatic tools.